Hunter Wellington boots fit true to size, if you are usually between sizes we recommend going one up.

If you wish to measure your foot or calf for a more accurate size selection, follow these steps.

Feet - Step One

Stand up straight on a hard surface with your heel against the wall and a piece of blank paper taped to the floor, flush against the wall beneath your foot.

Feet - Step Two

Have someone mark the longest part of your foot (referred to as heel-to-toe length) on the paper with a pen or pencil, or measure yourself if necessary. Repeat with the other foot, as right and left sizes may be different.

Feet - Step Three

Measure the longest part of your foot, taking the measurement from the back of your heel to the end of your big toe. Women should add 6mm to this measurement to allow for movement and room when the boot is used, men should add 8mm. This combined measurement will be your insole length, which you will find on all our size guides.

Calves - Step One

To find your calf measurement sit down on a chair with your knee bent at a 90-degree angle and your foot flat on the floor.

Calves - Step Two

You will want to measure your calf at the widest part without pulling the measuring tape tight.

Calves - Step Three

Measure both calves, if there is a different in the measurement, we suggest going with the bigger for sizing.

We recommend that you consider what clothing you’re likely to wear with your boots when measuring.

Think about which socks or trousers you will wear with the boots, and if you can measure with these items that will give you the most accurate measurements for wear.

If you are unable to measure with the clothing you are likely to wear, we suggest allowing 0.5cm with your measurements.

تسجيل دخول العميل:

سلة التسوق:

انضم لقائمتنا البريدية